Question 880
At fictional Maple Telecom, the network architecture group is preparing a proposal for telecom operations offices during the resilience walkthrough (case HPE7A11-2.3-113). The review identified this issue: a proposed AP model needs multigigabit wired connectivity but every planned access switchport is limited to 1 Gbps. Which recurring control most directly reduces the likelihood of this design problem returning?
Explanation
Correct Answer
This recurring control is targeted to the risk that A proposed AP model needs multigigabit wired connectivity but every planned access switchport is limited to 1 Gbps. The preventative action is to check AP-to-switch interface compatibility during BOM approval. The underlying design correction remains to align the access port speeds, cabling and AP capabilities with expected service load. Applied here, the relevant facts are: a proposed AP model needs multigigabit wired connectivity but every planned access switchport is limited to 1 Gbps. The question asks which recurring control most directly reduces the likelihood of this design problem returning.
Incorrect Answers
This option — “Run service-dependency fault testing before architecture signoff” — checks create wired and wireless topology and preliminary bom, not whether the design resolves the stated fault: a proposed AP model needs multigigabit wired connectivity but every planned access switchport is limited to 1 Gbps. The selected direct criterion is “Check AP-to-switch interface compatibility during BOM approval.”.
“Audit port mapping before switch model signoff” is a test of create wired and wireless topology and preliminary bom. That does not establish “Check AP-to-switch interface compatibility during BOM approval.” for the reported issue (a proposed AP model needs multigigabit wired connectivity but every planned access switchport is limited to 1 Gbps).
“Verify cable and transceiver compatibility by building” evaluates create wired and wireless topology and preliminary bom. The reported design gap is this: a proposed AP model needs multigigabit wired connectivity but every planned access switchport is limited to 1 Gbps. The required response is “Check AP-to-switch interface compatibility during BOM approval.”.