Question 570
At fictional Dovetail University, a network engineer supporting campus routing is reviewing IS-IS level-aware topology and database synchronization during a controlled failover exercise (HCIP-H12-821-ISIS-143). The observed network issue is: An IS-IS router is elected designated intermediate system on an Ethernet segment but an engineer calls it an OSPF DR. Which next engineering action best addresses the reported problem?
Explanation
Correct Answer
The directly responsive action is: Inspect the IS-IS DIS election and pseudonode LSP roles instead of applying OSPF DR rules. The specific reported fault is: An IS-IS router is elected designated intermediate system on an Ethernet segment but an engineer calls it an OSPF DR. Confirmation should show: The elected DIS originates the expected pseudonode and other routers form correct LAN adjacencies. The supporting technical principle is: IS-IS LAN DIS behavior differs from OSPF designated-router adjacency handling.
Incorrect Answers
“Align the intended IS-IS area identifiers or establish a deliberate Level 2 relationship” responds to another technical or business failure: Two Huawei routers share a link but their IS-IS NET addresses use different area identifiers while both are configured as Level 1. That source case depends on: IS-IS Level 1 adjacency requires compatible area membership. The present issue is: An IS-IS router is elected designated intermediate system on an Ethernet segment but an engineer calls it an OSPF DR. The more direct action is “Inspect the IS-IS DIS election and pseudonode LSP roles instead of applying OSPF DR rules” because IS-IS LAN DIS behavior differs from OSPF designated-router adjacency handling.
“Permit the appropriate IS-IS link-layer PDUs and check physical segment connectivity” responds to another technical or business failure: IS-IS adjacency remains Down when Hello frames are filtered by an intermediate layer-2 device. That source case depends on: IS-IS exchanges routing PDUs directly over the link rather than using ordinary IP multicast transport. The present issue is: An IS-IS router is elected designated intermediate system on an Ethernet segment but an engineer calls it an OSPF DR. The more direct action is “Inspect the IS-IS DIS election and pseudonode LSP roles instead of applying OSPF DR rules” because IS-IS LAN DIS behavior differs from OSPF designated-router adjacency handling.
“Examine the L1/L2 router's attached-state behavior and desired inter-area default routing” responds to another technical or business failure: An IS-IS Level 1 router gets an unwanted default path after an L1/L2 node reports reachability to other areas. That source case depends on: IS-IS attached-bit behavior can influence Level 1 routing toward other areas. The present issue is: An IS-IS router is elected designated intermediate system on an Ethernet segment but an engineer calls it an OSPF DR. The more direct action is “Inspect the IS-IS DIS election and pseudonode LSP roles instead of applying OSPF DR rules” because IS-IS LAN DIS behavior differs from OSPF designated-router adjacency handling.