Question 470
Fictional Sundale Logistics runs the billing integration workload at a western colocation storage site. While completing storage commissioning, the field handoff documents: A switch port reports repeated link flaps because the planned transceiver and cable type are not supported for the selected array interface speed. The team requires a direct technical explanation and measured acceptance check. Which preventive control most directly reduces this failure risk?
Explanation
Correct Answer
The ongoing safeguard is: Check switch optics inventory and supported array media before cutover. The recurring exposure to avoid is: The physical media and interface requirements were not matched between endpoints. A continuing effectiveness check is: Link state and counters remain healthy at the approved speed after patch correction.
Incorrect Answers
The offered choice addresses: Include model generation and slot labels in the step-by-step hardware runbook. That concerns nvram module placement check, rather than the specific failure described here. The deciding issue in this scenario is: The physical media and interface requirements were not matched between endpoints. The more directly applicable prevention choice is: Check switch optics inventory and supported array media before cutover.
This alternative concerns: Record install seating checks for each field-replaceable module. It is associated with controller module fully seated, rather than the question’s determining condition. The case instead turns on: The physical media and interface requirements were not matched between endpoints. The more directly applicable prevention choice is: Check switch optics inventory and supported array media before cutover.
The offered choice addresses: Freeze an approved target release in the installation work package. That concerns approved initial purity version, rather than the specific failure described here. The deciding issue in this scenario is: The physical media and interface requirements were not matched between endpoints. The more directly applicable prevention choice is: Check switch optics inventory and supported array media before cutover.