Cisco 200-301 Bundle

Root Guard holds the port in a root-inconsistent state if superior BPDUs arrive. That is not sufficient here: Enterprise WLAN security uses 802.1X/EAP against an authentication server.

The allowed list determines which tagged VLANs may traverse the trunk. That is not sufficient here: Enterprise WLAN security uses 802.1X/EAP against an authentication server.

Wireless QoS maps traffic classes to airtime/queuing behavior for supported workloads. That is not sufficient here: Enterprise WLAN security uses 802.1X/EAP against an authentication server.

Neither step is the requested pair: Disable CDP on that specific interface is for avoid exposing Cisco discovery information on an untrusted edge link, and Configure the switchport data access VLAN and switchport voice VLAN is for connect an IP phone and attached PC using distinct voice and data VLANs. Interface-level no cdp enable stops Cisco discovery advertisements on the selected port. The proposed plan misses the two stated outcomes.

The first step covers (1), but the second addresses avoid transmitting an administrator password in cleartext to a router CLI. SSH encrypts remote terminal data and authentication, whereas Telnet does not. It leaves outcome (2) unfulfilled.

The second step covers (2), but the first addresses enforce per-user identity authentication for an enterprise WLAN. Enterprise WLAN security uses 802.1X/EAP against an authentication server. It leaves outcome (1) unfulfilled.

Predictive ML estimates future conditions from measured historical trends. That is not sufficient here: Terraform models desired infrastructure resources and computes changes before applying them.

Incomplete or biased telemetry can produce misleading predictive network recommendations. That is not sufficient here: Terraform models desired infrastructure resources and computes changes before applying them.

Ansible inventories and playbooks run repeatable tasks across selected managed devices. That is not sufficient here: Terraform models desired infrastructure resources and computes changes before applying them.

The second step covers (2), but the first addresses avoid unattended visitors modifying shared network workstations. Basic endpoint hygiene and physical controls help protect logged-in administrative sessions. It leaves outcome (1) unfulfilled.

Neither step is the requested pair: Use accounting in an AAA architecture is for record when an administrator logs in and what actions occurred, and Create username entries with the secret option and appropriate privilege is for avoid storing new local user credentials as plain text. Accounting generates activity records for later auditing and troubleshooting. The proposed plan misses the two stated outcomes.

The first step covers (1), but the second addresses match any address in 10.3.8.0/24 using wildcard notation. A wildcard bit set to one means ignore that address bit for ACL matching. It leaves outcome (2) unfulfilled.

This prefix either cannot hold 28 usable hosts or allocates more addresses than the smallest valid subnet.

That explanation does not distinguish this option. “/26 (62 usable host IPs)” is an alternative action, but it does not by itself establish the outcome required in this case.

That explanation does not distinguish this option. “/29 (6 usable host IPs)” is an alternative action, but it does not by itself establish the outcome required in this case.

NTP status shows synchronization state, peers and stratum information. That is not sufficient here: The binding table lists leased addresses and client identifiers for the IOS DHCP service.

QoS queuing policies should reserve service for important classes without allowing one class unlimited capacity. That is not sufficient here: The binding table lists leased addresses and client identifiers for the IOS DHCP service.

DNS maps names to addresses, while DHCP leases IP settings and does not replace DNS. That is not sufficient here: The binding table lists leased addresses and client identifiers for the IOS DHCP service.

This targets a default route rather than the documented /24 route.

The wildcard mask is ACL syntax and does not identify the configured static subnet mask.

This adds or retains the route instead of removing it.

This /30 route is explicitly withdrawn from forwarding before the packet arrives, so it cannot be selected even though its prefix covered 10.44.238.59 originally.

This /8 prefix still matches 10.44.238.59, but the eligible /28 prefix is more specific, so this route is not selected.

This /16 prefix still matches 10.44.238.59, but the eligible /28 prefix is more specific, so this route is not selected.

Remote access VPNs establish an encrypted session for an individual endpoint. That is not sufficient here: A wildcard bit set to one means ignore that address bit for ACL matching.

A usable IPsec tunnel depends on peers authenticating and agreeing on protection parameters. That is not sufficient here: A wildcard bit set to one means ignore that address bit for ACL matching.

Authentication proves who or what is requesting access. That is not sufficient here: A wildcard bit set to one means ignore that address bit for ACL matching.

The second step covers (2), but the first addresses identify which router becomes the OSPF DR among two equal-priority routers. Higher router ID wins the DR election priority tie when both are otherwise eligible. It leaves outcome (1) unfulfilled.

Neither step is the requested pair: Configure the target prefix with the valid outgoing point-to-point interface is for install a route toward an adjacent directly connected point-to-point interface, and Recognize point-to-point OSPF network type is for explain why a point-to-point OSPF link has no DR election. On a point-to-point interface, the route can use the egress interface without Ethernet ARP for each host. The proposed plan misses the two stated outcomes.

The first step covers (1), but the second addresses install a static default IPv4 route to upstream neighbor 192.0.2.1. The all-zero destination and mask define the IPv4 default route via the next hop. It leaves outcome (2) unfulfilled.

Neither step is the requested pair: Select the switch with the lowest priority plus MAC bridge identifier is for identify the spanning-tree root switch from bridge IDs, and Configure spanning-tree portfast on a true endpoint-facing access port is for enable rapid host access without waiting for ordinary STP transitions. STP elects the lowest bridge ID as the root for a spanning-tree instance. The proposed plan misses the two stated outcomes.

The first step covers (1), but the second addresses publish a wireless network name for corporate users from a WLC. The WLAN profile binds an SSID to its wireless security and policy configuration. It leaves outcome (2) unfulfilled.

The second step covers (2), but the first addresses reject unsecured wireless client associations on a protected SSID. A secure SSID must negotiate the configured credentials and cipher before passing client data. It leaves outcome (1) unfulfilled.