Cisco 200-301 Bundle

Neither step is the requested pair: Configure the switchport data access VLAN and switchport voice VLAN is for connect an IP phone and attached PC using distinct voice and data VLANs, and Apply an appropriate WLC wireless QoS profile is for prioritize latency-sensitive voice clients over bulk wireless traffic. A voice VLAN allows supported phones to tag voice traffic separately while forwarding the PC's data VLAN. The proposed plan misses the two stated outcomes.

The second step covers (2), but the first addresses detect unauthorized wireless transmitters without serving client associations. A monitor-mode radio can scan spectrum and clients for management/security without providing ordinary access. It leaves outcome (1) unfulfilled.

The first step covers (1), but the second addresses change the untagged VLAN on a trunk to match a remote neighbor. Native VLAN mismatch can place untagged traffic into different Layer 2 broadcast domains. It leaves outcome (2) unfulfilled.

Emergencies admits only severity 0 and omits the requested immediate-action alerts at severity 1.

Critical is level 2 and would also send the critical messages the request excludes.

Errors includes severities 0–3, introducing both critical and error messages outside the requested threshold.

Not selected: Flood to other forwarding ports in that VLAN is for handle an unknown unicast destination received on one VLAN. Unknown unicast flooding is confined to the VLAN because the switch lacks a destination entry. This does not provide either of the two specified controls.

Not selected: Use a collapsed-core two-tier campus design is for build a small campus with a combined distribution and core layer. The access layer connects endpoints while the collapsed core aggregates access and provides routing. This is not one of the two required changes.

Not selected: Deploy a SOHO integrated gateway is for serve a home office with one combined firewall, switch, and wireless radio. An all-in-one small-office appliance consolidates routing, NAT, Ethernet access and Wi-Fi. This is outside the two requested outcomes.

A monitor-mode radio can scan spectrum and clients for management/security without providing ordinary access. That is not sufficient here: A secure SSID must negotiate the configured credentials and cipher before passing client data.

The logical port-channel is the switching interface whose member ports must have compatible settings. That is not sufficient here: A secure SSID must negotiate the configured credentials and cipher before passing client data.

Member interfaces require compatible Layer 2 parameters to join the same logical bundle. That is not sufficient here: A secure SSID must negotiate the configured credentials and cipher before passing client data.

Not selected: Use authorization policies for the requested action is for decide whether an authenticated user may issue a privileged configuration command. Authorization grants or denies specific operations after identity is established. This is not one of the two required changes.

Not selected: Select an appropriate WPA2/WPA3 protected security mode is for avoid deploying a weak open or legacy encrypted SSID for corporate users. Modern WLAN security limits passive interception and weak key recovery compared with WEP/open modes. This is outside the two requested outcomes.

Not selected: Add an explicit permit for eligible remaining traffic is for allow the rest of an ACL's traffic after a specific deny. Without a final permit, the implicit deny blocks traffic not otherwise matched. This does not provide either of the two specified controls.

This choice does not follow the observed LACP/port-channel state and would not correct the specified condition.

That explanation does not distinguish this option. “Assign every switch uplink to VLAN 1 as the only recovery” is an alternative action, but it does not by itself establish the outcome required in this case.

That explanation does not distinguish this option. “Use a static route to suppress LACP membership checks” is an alternative action, but it does not by itself establish the outcome required in this case.

POST commonly submits resource creation or actions with a payload. That is not sufficient here: 401 commonly indicates absent/invalid authentication, while 403 often signals insufficient authorization.

JSON numbers encode numeric data rather than text requiring parsing. That is not sufficient here: 401 commonly indicates absent/invalid authentication, while 403 often signals insufficient authorization.

Incomplete or biased telemetry can produce misleading predictive network recommendations. That is not sufficient here: 401 commonly indicates absent/invalid authentication, while 403 often signals insufficient authorization.

SSH server authentication depends on a usable host key rather than only configuring a VTY password. That is not sufficient here: DSCP bits in the IP header signal intended per-hop forwarding treatment.

Local device buffers can be lost on reboot, while a log server retains centralized history. That is not sufficient here: DSCP bits in the IP header signal intended per-hop forwarding treatment.

The NAT translation table lists original and translated addresses and ports for active entries. That is not sufficient here: DSCP bits in the IP header signal intended per-hop forwarding treatment.

A next-generation firewall can classify application traffic and track sessions before permitting flows. That is not sufficient here: A route in one VRF is not automatically visible in another without an explicit leak or import.

The all-ones host portion represents the subnet-directed broadcast in ordinary IPv4 subnets. That is not sufficient here: A route in one VRF is not automatically visible in another without an explicit leak or import.

Windows ipconfig /all displays detailed TCP/IP adapter configuration. That is not sufficient here: A route in one VRF is not automatically visible in another without an explicit leak or import.

An 802.1Q trunk tags most VLAN frames so several VLANs can share one interswitch link. That is not sufficient here: Layer 3 forwarding across VLANs requires an active routed interface for each subnet.

The VLAN table lists local VLAN membership for access ports and available VLAN identifiers. That is not sufficient here: Layer 3 forwarding across VLANs requires an active routed interface for each subnet.

Local-switching designs may place multiple client VLANs on the AP's wired uplink. That is not sufficient here: Layer 3 forwarding across VLANs requires an active routed interface for each subnet.

The first step covers (1), but the second addresses advertise basic device identity to a multivendor adjacent device. LLDP is a vendor-neutral Layer 2 discovery protocol that advertises neighbor identity and capabilities. It leaves outcome (2) unfulfilled.

Neither step is the requested pair: Use a supported out-of-band console connection is for manage a switch when its production network is unreachable, and Set the intended distribution switch's STP priority lower than competing bridges is for reduce the chance of an unintended access switch becoming STP root. A console provides local management access independent of in-band IP reachability. The proposed plan misses the two stated outcomes.

The second step covers (2), but the first addresses aggregate WLC uplinks for bandwidth and resilience. A compatible aggregated uplink spreads supported traffic across multiple physical links. It leaves outcome (1) unfulfilled.