Question 180
Original unofficial Cisco 350-501 SPCOR v1.1 service-provider network operations scenario: A route reflector receives multiple advertisements for a prefix, but an operator mistakes every entry in its BGP table for an active forwarding path. Which continuing control best reduces recurrence of this problem?
Explanation
Correct Answer
For this scenario, the observed situation is: A route reflector receives multiple advertisements for a prefix, but an operator mistakes every entry in its BGP table for an active forwarding path. The most directly supported response is: Identify the best path and distinguish candidate alternatives from installed forwarding routes. Technical basis: BGP may retain several path candidates while selecting a subset for best-path and forwarding use. Evidence of success: The routing and forwarding tables show only eligible installed next hops for the prefix. Ongoing protection: Use route-state and next-hop resolution verification in route-reflector troubleshooting.
Incorrect Answers
BGP routing policy controls prefix acceptance, while forwarding uses the most specific installed route. Maintaining that control would not track the failure described here. The relevant risk is: BGP may retain several path candidates while selecting a subset for best-path and forwarding use. Review this instead: Use route-state and next-hop resolution verification in route-reflector troubleshooting.
IS-IS Level-2 provides interarea reachability while Level-1 focuses on intraarea topology. Maintaining that control would not track the failure described here. The relevant risk is: BGP may retain several path candidates while selecting a subset for best-path and forwarding use. Review this instead: Use route-state and next-hop resolution verification in route-reflector troubleshooting.
The alternative guards against: NAT44 rewrites IPv4 addressing across a defined inside and outside interface boundary. The root condition for this case is: BGP may retain several path candidates while selecting a subset for best-path and forwarding use. The focused prevention check is: Use route-state and next-hop resolution verification in route-reflector troubleshooting.