Question 200
Original unofficial Cisco 350-501 SPCOR v1.1 service-provider network operations scenario: A router advertises an IPv4 route in BGP but its next hop is inaccessible from the ingress PE. Which continuing control best reduces recurrence of this problem?
Explanation
Correct Answer
For this scenario, the observed situation is: A router advertises an IPv4 route in BGP but its next hop is inaccessible from the ingress PE. The most directly supported response is: Restore reachable BGP next-hop resolution through the intended IGP or supported next-hop policy. Technical basis: BGP paths require resolvable next-hop reachability before installation and forwarding. Evidence of success: The route becomes eligible and the FIB points toward a reachable next hop. Ongoing protection: Monitor unresolved next-hop counters following transport topology changes.
Incorrect Answers
That recurring practice manages a separate exposure: BGP evaluates ordered criteria, so later comparisons apply only when earlier attributes are tied. The present case instead depends on: BGP paths require resolvable next-hop reachability before installation and forwarding. The suitable ongoing safeguard is: Monitor unresolved next-hop counters following transport topology changes.
That recurring practice manages a separate exposure: BFD supplies fast bidirectional failure detection independently of slower protocol hello timers. The present case instead depends on: BGP paths require resolvable next-hop reachability before installation and forwarding. The suitable ongoing safeguard is: Monitor unresolved next-hop counters following transport topology changes.
NAT64 bridges IPv6 endpoints to IPv4 destinations with state and addressing considerations. Maintaining that control would not track the failure described here. The relevant risk is: BGP paths require resolvable next-hop reachability before installation and forwarding. Review this instead: Monitor unresolved next-hop counters following transport topology changes.