Question 210
At fictional Quayside Education, a network engineer supporting learning sites is reviewing OSPF area design and link-state convergence during an intersite service activation (HCIP-H12-821-OSPF-053). The observed network issue is: An ASBR advertising multiple external subnets floods excessive details because external route aggregation was never applied. Which next engineering action best addresses the reported problem?
Explanation
Correct Answer
The directly responsive action is: Configure appropriate ASBR external route summarization while preserving necessary exceptions. The specific reported fault is: An ASBR advertising multiple external subnets floods excessive details because external route aggregation was never applied. Confirmation should show: The backbone receives the intended external aggregate and required exceptions. The supporting technical principle is: OSPF external aggregation occurs at the appropriate redistribution boundary.
Incorrect Answers
“Inspect the external LSA forwarding address and the routing table's ability to resolve it” responds to another technical or business failure: An external OSPF route prefers the wrong exit because its forwarding address is unreachable or unexpected. That source case depends on: OSPF external route next-hop selection can use the LSA forwarding address when present. The present issue is: An ASBR advertising multiple external subnets floods excessive details because external route aggregation was never applied. The more direct action is “Configure appropriate ASBR external route summarization while preserving necessary exceptions” because OSPF external aggregation occurs at the appropriate redistribution boundary.
“Apply compatible authentication settings and keys on both interfaces under controlled change” responds to another technical or business failure: An OSPF adjacency repeatedly fails due to mismatched authentication algorithms after a maintenance window. That source case depends on: OSPF routing exchanges depend on matched authentication parameters when authentication is enabled. The present issue is: An ASBR advertising multiple external subnets floods excessive details because external route aggregation was never applied. The more direct action is “Configure appropriate ASBR external route summarization while preserving necessary exceptions” because OSPF external aggregation occurs at the appropriate redistribution boundary.
“Check whether the devices are both DROthers and validate adjacency with the elected DR or BDR” responds to another technical or business failure: Two OSPF routers on a broadcast VLAN stay at 2-Way and an engineer wrongly treats every such neighbor as failed. That source case depends on: Broadcast OSPF does not require every pair of DROthers to form a full adjacency. The present issue is: An ASBR advertising multiple external subnets floods excessive details because external route aggregation was never applied. The more direct action is “Configure appropriate ASBR external route summarization while preserving necessary exceptions” because OSPF external aggregation occurs at the appropriate redistribution boundary.