Question 490
At fictional Harbor Media, a network engineer supporting streaming networks is reviewing IS-IS level-aware topology and database synchronization during a lab-to-production acceptance (HCIP-H12-821-ISIS-123). The observed network issue is: IS-IS adjacency remains Down when Hello frames are filtered by an intermediate layer-2 device. Which next engineering action best addresses the reported problem?
Explanation
Correct Answer
The directly responsive action is: Permit the appropriate IS-IS link-layer PDUs and check physical segment connectivity. The specific reported fault is: IS-IS adjacency remains Down when Hello frames are filtered by an intermediate layer-2 device. Confirmation should show: Neighbor Hellos are received and the intended adjacency reaches Up. The supporting technical principle is: IS-IS exchanges routing PDUs directly over the link rather than using ordinary IP multicast transport.
Incorrect Answers
“Inspect the IS-IS DIS election and pseudonode LSP roles instead of applying OSPF DR rules” responds to another technical or business failure: An IS-IS router is elected designated intermediate system on an Ethernet segment but an engineer calls it an OSPF DR. That source case depends on: IS-IS LAN DIS behavior differs from OSPF designated-router adjacency handling. The present issue is: IS-IS adjacency remains Down when Hello frames are filtered by an intermediate layer-2 device. The more direct action is “Permit the appropriate IS-IS link-layer PDUs and check physical segment connectivity” because IS-IS exchanges routing PDUs directly over the link rather than using ordinary IP multicast transport.
“Examine the L1/L2 router's attached-state behavior and desired inter-area default routing” responds to another technical or business failure: An IS-IS Level 1 router gets an unwanted default path after an L1/L2 node reports reachability to other areas. That source case depends on: IS-IS attached-bit behavior can influence Level 1 routing toward other areas. The present issue is: IS-IS adjacency remains Down when Hello frames are filtered by an intermediate layer-2 device. The more direct action is “Permit the appropriate IS-IS link-layer PDUs and check physical segment connectivity” because IS-IS exchanges routing PDUs directly over the link rather than using ordinary IP multicast transport.
“Align interface circuit-level settings with the intended Level 2 topology” responds to another technical or business failure: Two Level 2 IS-IS routers do not form neighbors because one interface is configured for Level 1-only adjacencies. That source case depends on: IS-IS adjacency level selection determines which databases neighbors can share. The present issue is: IS-IS adjacency remains Down when Hello frames are filtered by an intermediate layer-2 device. The more direct action is “Permit the appropriate IS-IS link-layer PDUs and check physical segment connectivity” because IS-IS exchanges routing PDUs directly over the link rather than using ordinary IP multicast transport.